If you have a burnt out bulb, don’t worry because there is a remedy to fix it. You will no longer call the electrician, but you will have it repaired in less than 60 seconds. You’ll save money and time: let’s find out more.
If you have a burnt out light bulb at home, don’t think about throwing it away or replacing it because you can fix it in just a few steps. This method can help you solve the problem in one minute, incredible to believe but it’s true. Stop throwing money away, you can fix it with little. It’s a technique that electricians use, it’s really very simple: let’s find out how to do it.
Lamp burnt out, that’s why it happens
The bulb can burn out because of various reasons. For instance, if the voltage of the power supply to the house is too high. Avoid turning your bulbs on and off too often during the day, as you risk electrocuting them.
This happens, even when a connection is not correctly attached to the socket of a bulb, in fact, it is good to check if everything is well soldered, but remember first to disconnect the power, each electrical operation must be done safely .
Or, if you notice that the bulb has suddenly gone out and burned out, it could be due to a short circuit. But why does this happen? It may happen that the electric current does not run in its established path, therefore, strong friction is created.
So in this case, the faulty part must be repaired. In short, the causes can be multiple, however, do you know how to repair a burnt out bulb in a short time? What we are going to reveal to you is the method that electricians use. Very little goes a long way: let’s find out more.
The procedure for repairing a burnt out light bulb: quick and easy :
To repair a burnt out light bulb, you will need a small screwdriver, electrical tape, LED wire, and needle-nose pliers. Before you begin, remember to turn off the power to the lamp, this is the first step to working safely.
Firstly, use the screwdriver to remove the broken LED bulb from the lamp, be careful not to touch the glass of the bulb, otherwise you may get burned. After removing the broken bulb, remove the filament from the broken bulb with needle-nose pliers.
Next, you will need to replace the LED string that you purchased from your trusted hardware store. Solder it perfectly using adhesive tape. Finally, insert the bulb into the lamp and turn it back on.
You will repair it in just a few steps, in less than 2 minutes. Incredible right? Do-it-yourself remedies are always the best, because in addition to being cheap, they are also very easy, practical and quick. However, if you do not feel confident carrying out this small operation, contact an electrician.
